Mopar A E Body 74-76 Dodge Plymouth 3.5" STAINLESS Steering Column Coupler Cover Clamp / Retainer

DMT 3.5" (overall coupler length) STAINLESS STEEL reproduction of Chryslers steering coupler cover retaining clamp. These stainless parts have a satin finish so the LOOK like plain steel parts BUT they won't rust. 
Chrysler part# for original steel clamp 2996935.

1974 74 1975 75 1976 76 Dart, Dart Sport, Duster, Swinger, Valiant

1974 Barracuda, Challenger

80's Van and late 70's and 80's Trucks

IMPORTANT!!!! Parts were swapped over the past 50 years. Your steering column or coupler could have come from an earlier car with a shorter 3.0" coupler. IT IS YOUR RESPONSIBILITY TO VERIFY THE LENGTH. THESE ARE NOT RETURNABLE.

IMPORTANT!!! These do not fit all aftermarket couplers. The DO fit factory 3.5" couplers. They also fit the new 3.5" couplers being sold by Vans Auto.

Picture shows parts assembled on a coupler. Coupler body, cap and seal are NOT included. Picture is for LENGTH MEASUREMENT reference only. Early, 65-73, 3.0" long coupler is shown on the right.

Also have listings for both retainers with the black rubber seal and new stainless cover.

Material(s)
Stainless wire cover clamp